INDUSTRIAL DEGREASER FG is an innovative solvent blend that is excellent for use where rapid turnaround is necessary and low flash point solvents can be used. Dissolves and removes:
- Greases
- Oils
- Lubricants
- Adhesives and contaminants from:
- Equipment
- Machinery
- Motors and metal parts
- NSF A8 and K1 registered (N 140255 and 140250) for use in food industry
- Cuts through dirt and grease
- Fast evaporation to minimise downtime leaves no residues
- Easy 'in place' cleaning with minimal odour
- Non-corrosive and non-staining
- Safe on most plastics coatings and rubbers (always test prior to use)
- Aerosol fitted with a 360° Spray System for all angle use - even upside down
APPLICATIONS
- Electric motors & Mechanical brakes and clutches
- Air tools & Pumps
- Material handling equipment & Dies
- Generators & Air conditioners and compressors
- Wire ropes & Bearings
- General degreasing and oil removal & Fork lift trucks
- Sprockets & Moulds
- Chains
DIRECTIONS
- Can be used by:
- Spraying
- Immersion
- Dipping or Wiping
For tough soiling - apply product and agitate to loosen contaminants
- Apply liberally and allow excess to run off
- Air dry or dry with absorbent cloth. Repeat if necessary
- Test a small area prior to use to check materials compatibility. Do not use on sensitive electronic equipment
- Ensure adequate ventilation. Do not use on energised equipment
- Rinse with potable water. Allow to dry thoroughly and vapours disperse before reactivating system
SPECIFICATIONS
- NSF Registered - Category : Aerosol A8 + K1 (N 140255) : Bulk A8 + K1 (N 140250)
- Appearance : Colourless Liquid - Sweet Odour
- Specific Gravity (@ 20°C) : 0.808
- Flash Point (closed cup) : 25°C
- Boiling Range : 100-170°C
- Freezing Point : < -30°C
- Evaporation Rate (ether = 1) : 19
- Vapour Density (vs air = 1) : 4
- Kauri-Butanol Value : > 150
- Hildebrand Solubility Parameter (calc.) : 8.206
- Hydrogen Bonding Index (calc.) : 0.384
- Fractional Polarity (calc.) : 0.037
- Viscosity (@ 20°C calc.) : 0.76 mPa.s
- Surface Tension (@ 25°C est.) : 23 mN/m
- Plastics Compatibility : Safe On Most Plastics (Test Prior To Use)
STORAGE
The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.