AMBERSIL 40+ is the complete maintenance treatment for protection against:

• Corrosion
• Water displacement
• Lubrication and Light surface rust removal

One simple application - by spray - swab or dip - stops the spread of existing corrosion - gives lasting protection against further attack and removes and repels ambient moisture.Ambersil 40+ is ideal for use on all mechanical and electrical equipment. As a penetrant - it will quickly free seized nuts - bolts and bearings whilst the highly effective water displacing properties make 40+ the perfect damp-start solution for ignition systems and other electrical equipment.The protective lubricating film is non-conductive and remains operational even at severe sub-zero temperatures. It will not affect paints or plastics and is lastingly effective on all metals; including aluminium. Freshly machined surfaces resist finger-printing and will stay clean and bright -even in highly corrosive conditions. Fitted with a 360 degree Spray System for all angle use - even upside down

• Appearance : Amber coloured liquid
• Odour : White Spirit
• Specifications/Approvals : Rolls Royce Item 1036J - Approved Supplier 176
• Ford Tox No. 114469
• SG @ 25C : 0.79
• Pressure @ 25C : 5 Bar (aerosol)
• Discharge rate : 1.2g/sec (aerosol)
• Initial boiling point 147C
• Temperature range : Operational from 20C to +115C
• Moisture content : Less than 700 ppm
• Corrosion protection : 200 hours in BS 3900 F4 Salt Spray Test
• Solubility : Soluble in solvents - insoluble in water
• Film Thickness : 1.65 x 10-4 cm
• Film Weight : 1.46 g/sq. metre

Compatibility :

• Rubber
• No visible affect when sprayed. Most rubbers will swell after prolonged immersion
• Paintwork
• No affect on surface. Wax polishes and coatings may be softened after prolonged exposure
• Plastics
• No visible affects after 240 hours immersion of:
• Formica
• Acrylic sheet
• Polyester glass fibre laminate
• Epoxy glass fibre laminate
• Vinyl sheet and Ebonite
• Over-painting
• Although not always necessary - removal of 40+ form surfaces to be painted is recommended

• Flammability : Classified as extremely flammable under CHIP Regulations
• Flashpoint : 43OC for non-aerosol
• Packaging : 400ml aerosol

STORAGE

The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.